H3C SR6600 Command Reference Manual

Also see for SR6600 SPE-FWM: Configuration guide Configuration guide Configuration guide Command reference Command reference

3-62Field DescriptionData in Interval 2:0 Line Code Violations, 0 Path Code Violations0 Ais Alarm Secs, 900 Los Alarm Secs23 Slip Secs, 900 Fr Loss Secs, 0 Line Err Secs, 0Degraded Mins0 Errored Secs, 0 Bursty Err Secs, 0 Severely ErrSecs, 900 Unavail SecsStatistics spanning the second interval.The statistical items are the same as those providedby the statistics spanning the current interval.Total Data (last 2 15 minute intervals):0 Line Code Violations, 0 Path Code Violations0 Ais Alarm Secs, 2087 Los Alarm Secs52 Slip Secs, 2087 Fr Loss Secs, 0 Line Err Secs, 0Degraded Mins0 Errored Secs, 0 Bursty Err Secs, 0 Severely ErrSecs, 2087 Unavail SecsStatistics spanning the last two intervals.The statistical items are the same as those providedby the statistics spanning the current interval.error-diffusion restraint configSyntaxerror-diffusion restraint config detect-timer renew-timer thresholdundo error-diffusion restraint configViewSystem viewDefault Level2: System levelParametersdetect-timer: Period to check error packets, in the range 30 to 600 (in seconds).renew-timer: Period after which an interface resumes it function, in the range 120 to 2,400 (in seconds).threshold: Ratio of error packets in percentage, in the range 5 to 100.DescriptionUse the error-diffusion restraint config command to set the three parameters in error packetsdiffusion restraint.Use the undo error-diffusion restraint config command to restore the default values of the threeparameters.The default value for detect-timer is 30 seconds, for renew-timer 600 seconds, and for threshold 20.The value of renew-timer must be at least four times of detect-timer. If the number of error packetsreceived during detect-timer is less than 100, they will be ignored by the system.This command applies only to CT1, CE1, E1-F, and T1-F interfaces only.