H3C SR6600 Command Reference Manual

Also see for SR6600 SPE-FWM: Configuration guide Configuration guide Configuration guide Command reference Command reference

3-92Parametersinterface-number: CT3 interface number. In conjunction with the t3 keyword, it specifies a CT3interface.DescriptionUse the display controller t3 command to display state information about one specified or all CT3interfaces.In addition to the state information about the CT3 interface, the command displays information abouteach T1 line on the CT3 interface if the interface is working in CT3 mode.Examples# Display information about interface T3 2/0/0. display controller t3 2/0/0T3 2/0/0 current state :UPDescription : T3 2/0/0 Interfacesic Configuration:Work mode is CT3, cable length is 49 feet.Frame-format is C-BIT Parity, line code is B3ZS.Source clock is slave, loopback is not set.Alarm state:Receiver alarm state is none.MDL state:No message is sent now.Message data elements:EIC: line, LIC: line, FIC: line, UNIT: lineFI: line, PORT_NO: line, GEN_NO: linePeriodical detection is disabled.FEAC state:No code is sent now.Periodical detection is enabled, no code received now.BERT state:(stopped, not completed)Test pattern: 2^7, Status: Not Sync, Sync Detected: 0Time: 0 minute(s), Time past: 0 minute(s)Bit errors (since test started): 0 bitsBits received (since test started): 0 MbitsBit errors (since latest sync): 0 bitsBits received (since latest sync): 0 MbitsHistorical Statistics:Last clearing of counters: 14:39:02 UTC Sat 06/25/2005Data in current interval (22 seconds elapsed):0 Line Code Violations, 0 Far End Block Error0 C-Bit Coding Violation, 0 P-bit Coding Violation0 Framing Bit Err, 0 Severely Err Framing Secs0 C-bit Err Secs, 0 C-bit Severely Err Secs0 P-bit Err Secs, 0 P-bit Severely Err Secs0 Unavailable Secs, 0 Line Err SecsT3 2/0/0 CT1 1 is upFrame-format ESF, clock slave, loopback not setFDL Performance Report is disabled