CLI Command ReferenceserviceMakito X User’s Guide, v2.2, Issue 02 339serviceS YNOPSISservice name actionwhere:DESCRIPTIONFor security purposes, you may need to stop one or more network services from accessingthe Makito X. The service command is used to enable and disable the following networkservices: all, or HTTP, Pass-through, SNMP, SSH, Talkback, Telnet, and VF.On the Makito X with SDI, pass-through allows the serial port to be used as a pass-through interface to control serially attached devices such as PTZ controlled cameras.IMPORTANT If the COM1 port is not configured for CLI Management, and all remotemanagement interfaces (HTTP, telnet, SSH, and SNMP) are disabled, the only way to re-enable these services is by a Factory Reset. (For details, see “Resetting the Encoder” onpage 58.) Once the serial port is configured for metadata or passthrough use, it is nolonger usable for CLI management.A CTIONSEXAMPLESname can be: all, http, passthrough, snmp, ssh, talkback,telnet, vfstart Activates the service immediately and configures the unit so thatthe service will be started automatically when the unit is rebooted.stop De-activates the service immediately and configures the unit sothat the service will be disabled when the unit is rebooted.restart Restarts the service and configures the unit so that the service willbe started automatically when the unit is rebooted.status Displays the current status of the service, i.e., if it has beenstarted or stopped. Also displays the startup status of the service.# service telnet stopStops telnet connection to the Makito X.
