8 - 2 2020/4820/4820 i User’s GuideStep 1 - Take a Picture Using IMGSNPImage Snap - IMGSNPAn image is taken whenever the hardware button is pressed, or when the ImageSnap (IMGSNP) command is processed.The image snap command has many different modifiers that can be used tochange the look of the image in memory. Modifiers always begin with numbersand end with a letter (case insensitive). Any number of modifiers may beappended to the IMGSNP command. For example, you can use the followingcommand to snap an image, increase the gain, and have the beeper sound oncethe snap is complete:IMGSNP2G1BIMGSNP ModifiersP - Imaging StyleThis sets the Image Snap style.0P Decoding Style. This processing allows a few frames to betaken until the exposure parameters are met. The last frame isthen available for further use.1P Photo Style(default). This mimics a simple digital camera, andresults in a visually optimized image.2P Manual Style. This is an advanced style that should only beused by an experienced user. It allows you the most freedom toset up the imager, and has no auto-exposure.B - BeeperCauses a beep to sound after an image is snapped.0B No beep(default)1B Sounds a beep when the image is captured.T - Wait for TriggerWaits for a hardware button push before taking the image. This is onlyavailable when using Photo Style (1P).0T Takes image immediately(default)1T Waits for a button push, then takes the image
