1 - 8 2020/4820/4820 i User’s GuideLinking Image Scanner to BaseWhen newly shipped or defaulted to factory settings, the base and imagescanner are not linked. Once the image scanner is placed into the base, thesoftware automatically links the image scanner and the base. If the imagescanner and base have previously been linked, you do not receive any feedback.If this is the first time that the image scanner and base are linked, both devicesemit a short chirp when their radios link. At this point, you are set to one imagescanner to one base.1. Provide power to the base.2. Place the image scanner into the base. The image scanner and base link.3. To determine if your cordless system is set up correctly, scan one of thesample barcodes in the back of this manual. If the image scanner provides asingle good read beep and the green LED lights, the image scanner hassuccessfully linked to the base. If you receive a triple error beep and the redLED lights, the image scanner has not linked to the base. Refer to page 14-4 for troubleshooting information.Communication Between the Cordless Systemand the HostThe cordless image scanner provides immediate feedback in the form of a “goodread” indication (a green LED on the image scanner and an audible beep) aftera barcode is scanned correctly and the base has acknowledged receiving thedata. This is possible since the cordless system provides two-waycommunication between the image scanner and the base.Image Scanner2020 Cordless BaseGreen LEDRed LED
