2 - 2 2020/4820/4820 i User’s GuideRS-232The RS-232 Interface barcode is used when connecting to the serial port of a PCor terminal. The following RS-232 Interface barcode also programs a carriagereturn (CR) and a line feed (LF) suffix, baud rate, and data format as indicatedbelow. It also changes the trigger mode to manual.Wand Emulation Plug & PlayIn Wand Emulation mode, the image scanner decodes the barcode then sendsdata in the same format as a scanner image scanner. The Code 39 Formatconverts all symbologies to Code 39.The Same Code Format transmits UPC, EAN, Code 128 and Interleaved 2 of 5without any changes, but converts all other symbologies to Code 39.TheWand Emulation Plug & Play Code 39 Format barcode below sets theterminal ID to 61. TheWand Emulation Plug & Play Same Code Formatbarcode sets the terminal ID to 64. These Plug & Play barcodes also set theTransmission Rate to 25 inches per second, Output Polarity to black high, andIdle State to high. (If you want to change the terminal IDonly, without changingany other image scanner settings, please refer to Programming the Interface -Terminal ID Method on page 2-7.)Option SettingBaud Rate 115200 bpsData Format 8 data bits, no parity bit, 1 stop bitRS-232 InterfaceWand EmulationPlug & PlaySame CodeWand EmulationPlug & Play(Code 39 Format)
