3 - 12 2020/4820/4820 i User’s GuideResetting the Standard Product Default Settings:All Application Work GroupsThe following barcode defaults all of the work groups to the factory settings.The Menu Commands, beginning on page 12-5 list the standard product defaultsettings for each of the commands (indicated by an asterisk (*) on theprogramming pages).Resetting the Standard Product Default Settings:Current Application Work GroupIf you aren’t sure what programming options are in your image scanner, or you’vechanged some options and want the standard product default settings restored,scan theStandard Product Default Settings: Current Application Groupbarcode below.The Menu Commands, beginning on page 12-5 list the factory default settings foreach of the commands (indicated by an asterisk (*) on the programming pages).Note: Scanning this barcode also causes both the image scanner and the baseto perform a reset and become unlinked. The image scanner must beplaced in its base to re-establish the link before any setup codes areentered. Refer to "Image Scanner Modes" on page 3-5 for additionalinformation.Note: If your image scanner is in multiple image scanner mode and you scaneither the current or all application group default barcode, you will hear upto 30 seconds of beeping while all image scanners are re-linked from thebase and the settings are defaulted to * settings. The default interface iskeyboard wedge and the default image scanner mode is single imagescanner locked link mode.Standard Product Default Settings:All Application GroupsStandard Product Default Settings:Current Application Group
