3800i/3800r User’s Guide 3 - 13The breakdown of the command line is shown below:SEQBLK sequence editor start command62 code identifier for Code 390011 Code 39 code length (9) plus CR suffix (2) = 1141 start character match for Code 39, 41h = “A”FF termination string for first code6A code identifier for Code 1280012 Code 128 code length (10) plus CR suffix (2) = 1242 start character match for Code 128, 42h = “B”FF termination string for second code69 code identifier for Code 930011 Code 93 code length (9) plus CR suffix (2) = 1143 start character match for Code 93, 43h = “C”FF termination string for third codeMultiple SymbolsNote: This feature does not work when the scanner is in Low Power mode.When this programming selection is turnedOn, it allows you to read multiplesymbols with a single pull of the scanner’s trigger. If you press and hold thetrigger, aiming the scanner at a series of symbols, it reads unique symbols once,beeping (if turned on) for each read. The scanner attempts to find and decodenew symbols as long as the trigger is pulled. When this programming selectionis turnedOff, the scanner will only read the symbol closest to the aiming beam.No ReadWith No Read turnedOn, the scanner sends an “NR” to the host if you pull andrelease the trigger without reading a code (e.g., bad bar code). If No Read isturnedOff, the “NR” will not be sent to the host.On* OffOn* Off
