Hand Held Products SV Series User Manual

Contents

6 - 42 Quick Check® SV Series User’s Guide~HxThis command stores all parameters into non-volatile memory. This commandshould be the last command sent after parameters are programmed via theabove commands.Mode 17 (~LV17)I/O operation1. System will operate in Edge Sync or Envelope sync mode (~LX#).2. Sync polarity programmable (~LP#)3. Use ~PR0200 for proper port initialization.4. Port 1 will pulse active ON for a bar code quality or data error condition.5. Port 2 will pulse active ON for a NO READ, partial or low % decode errorcondition.6. Port 3 will pulse active ON for a non-error condition.7. Port pulse times programmable. (~PP801xxx)8. Pulses act like re-triggerable 1-shot logic9. Pushing the reset button or power re-cycle will place Ports 1, 2 and 3 in theirinactive states and reset the # codes per sync counter.10. Error conditions available are:a. Partial Read (Programmable, ( ~Lp#, LQ#)b. % decode (Programmable, ~LD##)c. Bad Quiet Zone: < 10X (~PB816xxx100)d. ISO Defects grade (Programmable, ~PB806xxx000)e. ISO Decodability grade (Programmable, ~PB802xxx100)f. Symbol Contrast grade (Programmable, ~PB804xxx100)g. Overall ISO Grade (Programmable, ~LAxx)h. No Read (if sync is received)i. Number of codes per sync programmable (~LN##, ~LZ##)j. X dimension Range (Programmable ~PB811xxxyyy)k. Ratio (Programmable ~PB815xxx000)l. Symbology Mod Check data error