Hand Held Products SV Series User Manual

Contents

Quick Check® SV Series User’s Guide 6 - 51~LDxxThis command sets the % decode threshold for a passing condition. If analyzingpoorly printed symbols, it is recommended that partial decodes be enabled at thedecoder level when this command is enabled.xx = failure threshold. Example ~LD75: if 74 % or less of scans on a code werenot fully decoded, this sets a failure for this parameter.~PB816xxx100This command sets the minimum percent of scans on a code which calculategood quiet zones to determine an acceptable quiet zone analysis. The field xxxis the minimum passing threshold. Example: if xxx = 030, a minimum of 30% ofall fully decoded scans on a code must calculate a good quiet zone, or a failurecondition is set for this parameter.~PB806xxx000This command sets the threshold for the ISO Defects calculation on a code to seta failure condition. The field xxx is the passing threshold for the calculation. Forexample: if xxx = 025, a Defects analysis of 26% or higher will cause a failurecondition for this parameter.~PB802xxx100This command sets the threshold for the ISO Decodability calculation on a codeto set a failure condition. The field xxx is the passing threshold for thecalculation. For example: if xxx = 037, a Decodability analysis of 36% or lowerwill cause a failure condition for this parameter.~PB804xxx100This command sets the threshold for the ISO Symbol Contrast calculation on acode to set a failure condition. The field xxx is the passing threshold for thecalculation. For example: if xxx = 020, a Symbol Contrast analysis of 19% orlower will cause a failure condition for this parameter.~PB815xxx000This command sets the threshold for the ratio calculation on a code to set afailure condition. The field xxx is the passing threshold for the calculation. Forexample: if xxx = 025, a ratio analysis of 2.4 or lower will cause a failure conditionfor this parameter.~PB811xxxyyyThis command sets the threshold for acceptable X dimension ranges. The valuefor xxx is the narrowest acceptable X dimension. The value yyy is the widestacceptable X dimension. Units are in .001 inch (mils). For example:~PB811010020 will cause a failure for an X dimension less than 10 mils orgreater than 20 mils.~LN##This command sets the minimum number of codes to be read during a syncperiod. ## = the number of codes. For example: ~LN02 causes a No Readcondition to be set if less than 2 bar codes are fully decoded during a syncinterval. See the ~LZ## (page 6-17) command below for priority.