615 - OperationFilling through tank lidThe tank is filled with water through the filling hole by removing thelid located on the top of the tank. The water used should be as clean aspossible to obtain best results.Fill the tank using the filter to prevent impurities from entering thetank. For greater filling capacity, an overhead tank can be used.DANGER! Do not place the filling hose inside the tank. Keep itout of the tank at all times and only point it towards the fillinghole. If the pressure hose were placed inside the tank and therewas a drop in water supply pressure, the chemical productcould be syphoned back and contaminate the water supplylines, plant and well.ATTENTION! The water supply line should be provided with a check valve as additional safety precaution. Followlocal legislation in force at any time.ATTENTION! The water supply should be provided with a meter to avoid spillage by over-filling. Follow locallegislation in force at any time.Filling the rinsing tankThe rinsing tank is integrated with the main tank.Capacity: 40 , 60 or 100 litres for 400, 600 , 1000 and 1200 litres maintanks, litres for 2000 .The illustration shows the location of the rinse tank. Fill though lid A.ATTENTION! Only fill rinsing tank with clean water! To avoidalgae developing in the rinsing tank always drain the rinsingtank if the sprayer is not in use for a longer period of time.To clean the tank select “Rinsing tank” on the three-way valve locatedabove the suction filter.The multi-hole rinsing nozzle is located inside the main tank.When pressurized the multi hole nozzle will rotate fast and rinse downspray chemical residues from the tank walls. To activate this multi-holerinsing nozzle for internal cleaning you should turn the tap located onthe pressure distributor.