28 Netfinity 3500-M20 – Type 8657 Models 21Y, 22Y, 31Y, 32Y,UNIX messagesThis section provides descriptions of the Ethernet error mes-sages for the SCO UNIX LLI driver, and suggested actionsto resolve each problem.PermaNetServer:Switching back to Primary Adapter.Explanation: The primary Ethernetconnection is now operating correctly.Network traffic will automatically transferto the primary Ethernet controller.Action: None needed, message is forinformation only.Table 5. UNIX LLI driver messages for the Ethernetcontrollerpnt0-2 PCI search specified, PCI device not found!Explanation: The driver cannot locate theEthernet controller on the PCI bus.Action:• Run the NETCONFIG program to searchfor another Ethernet controller• Verify that the Ethernet controller isenabled. If the Ethernet controller isenabled, run the diagnostic programs.pnt0-6 Cannot allocate memory for the adapterduring an interrupt. Please check theStreams parameters.Explanation: On a SunSoft Solaris system,this message indicates that the system is out ofStreams memory blocks.Action: Use the CRASH utility to increase thenumber of Streams memory blocks. Modify theinterrupt request (IRQ) settings in theConfiguration/Setup Utility program, or run theNETCONFIG program to match the hardwaresettings.pnt0-7 Cannot allocate memory for the adapterduring reset. Please check the Streamsparameters.Explanation: The system is out of Streamsmemory blocks.Action: Use the CRASH utility to increase thenumber of Streams memory blocks.Table 4. NDIS (Windows NT) driver messages for theEthernet controller
