Access holesRelease tabs5. Disconnect any cables from the adapter.6. Carefully grasp the adapter by its top edge or upper corners, and pull theadapter from the PCI slot.7. If you have other optional devices to install or remove, do so now. Otherwise,go to “Completing the installation” on page 81.Installing a Remote Supervisor Adapter II SlimLineAn optional Remote Supervisor Adapter II SlimLine can be installed only in adedicated slot on the system board. See “System-board optional-device connectors”on page 17 for the location of the connector. After the Remote Supervisor Adapter IISlimLine is installed, the systems-management Ethernet port on the rear of theserver is active.Note: Earlier versions of the Remote Supervisor Adapter II SlimLine might not workin this server. See http://www.ibm.com/servers/eserver/serverproven/compat/us/ forthe supported Remote Supervisor Adapter II SlimLine.Chapter 2. Installing optional devices 43
