Removing a Remote Supervisor Adapter II SlimLineNote: Before you remove a Remote Supervisor Adapter II SlimLine, create abackup copy of the configuration so that if you are replacing the adapter, you canrestore the configuration.Remote SupervisorAdapter II SlimLine Latch bracket tabsRetainer bracketTo remove the Remote Supervisor Adapter II SlimLine, complete the followingsteps:1. Read the safety information that begins on page vii and “Installation guidelines”on page 28.2. Turn off the server and peripheral devices and disconnect all power cords andexternal cables (see “Turning off the server” on page 13).Attention: In a dc power environment, only trained service personnel otherthan IBM service technicians are authorized to connect or disconnect power tothe dc power supply. See the documentation that comes with each dc powersupply.3. Remove the cover (see “Removing the cover” on page 31).4. Remove the PCI riser-card assembly.5. Spread the tabs of the latch bracket apart and lift the end of the RemoteSupervisor Adapter II SlimLine, until the tabs release the adapter; then, slide theother end of the Remote Supervisor Adapter II SlimLine out of the retainerbracket.6. Lift the Remote Supervisor Adapter II SlimLine out of the server.7. Replace the PCI riser-card assembly.If you have other optional devices to install or remove, do so now. Otherwise, go to“Completing the installation” on page 81.Chapter 2. Installing optional devices 45
