a. Make sure that the microprocessor-tray release latch is open; then, pushthe microprocessor tray into the server.b. Close the tray levers and make sure that they are securely latched.c. Press the microprocessor-tray release latch down.d. Reinstall the fans and memory cards in the server.If you have other options to install or remove, do so now; otherwise, go to“Completing the installation.”Completing the installationTo complete the installation, complete the following steps:1. If you removed the server cover, place the cover-release latch in the open (up)position. Insert the bottom tabs of the top cover into the matching slots in theserver chassis. Press down on the cover-release latch to lock the cover inplace. Replace the bezel, if you removed it.BezelTop coverCover releaselatch2. Install the server in a rack. See the Rack Installation Instructions that come withthe server for complete rack installation and removal instructions.Attention:v Install the server only in a rack cabinet with perforated doors.v Do not leave open spaces above or below an installed server in the rackcabinet. To help prevent damage to server components, always install a blankfiller panel to cover the open space and to help ensure proper air circulation.See the documentation that comes with your rack cabinet for moreinformation.3. Connect the cables and power cords. See “Connecting the cables” on page 48for more information.Chapter 2. Installing options 47
