| 
– powerTurn the server on and off remotely.– rebootForce the server to restart.– sel getDisplay the BMC system event log.– solConfigure the SOL function.– sysinfoDisplay system information that is related to the server and the globallyunique identifier (GUID).Using the SAS/SATA Configuration Utility programUse the SAS/SATA Configuration Utility program to configure SAS devices.Starting the SAS/SATA Configuration Utility programTo start the SAS/SATA Configuration Utility program, complete the following steps:1. Turn on the server.2. When the prompt <<< Press for Adaptec SAS/SATA ConfigurationUtility! >>> appears, press Ctrl+A.3. To select a choice from the menu, use the arrow keys.4. Follow the instructions on the screen to change the SerialSelect Utility or DiskUtilities settings.SerialSelect Utility menu choicesThe following choices are on the SerialSelect Utility menu:v SAS Controller ConfigurationSelect this choice to view or change SAS controller settings. To reset thecontroller to its default settings, press F6 and follow the instructions on thescreen.v PHY ConfigurationSelect this choice to view or change PHY configuration settings. To reset thecontroller to its default settings, press F6 and follow the instructions on thescreen.Disk UtilitiesSelect this choice to format, verify, or locate SAS devices. Select a device from thelist and read the instructions on the screen carefully before making a selection.Using ServeRAID ManagerUse ServeRAID Manager, which is on the IBM ServeRAID Support CD, to:v Configure a redundant array of independent disks (RAID) arrayv Restore a SCSI hard disk drive to the factory-default settings, erasing all datafrom the diskv View the RAID configuration and associated devicesv Monitor the operation of the RAID controllersChapter 3. Configuring the server 79 |
