IBM Aptiva 2162 Series Hardware Maintenance Service

Federal Communications Commission (FCC) NoticeThe following statement applies to this IBM product. The statement for otherIBM products intended for use with this product will appear in theiraccompanying manuals.Federal Communications Commission (FCC)StatementNote: This equipment has been tested and found to comply with the limitsfor a Class B digital device, pursuant to Part 15 of the FCC Rules. Theselimits are designed to provide reasonable protection against harmfulinterference in a residential installation. This equipment generates, uses,and can radiate radio frequency energy and, if not installed and used inaccordance with the instructions, may cause harmful interference to radiocommunications. However, there is no guarantee that interference will notoccur in a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined byturning the equipment off and on, the user is encouraged to try to correct theinterference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that towhich the receiver is connected. Consult an IBM authorized dealer or service representative for help.Properly shielded and grounded cables and connectors must be used inorder to meet FCC emission limits. Proper cables and connectors areavailable from IBM authorized dealers. IBM is not responsible for any radioor television interference caused by using other than recommended cablesand connectors or by unauthorized changes or modifications to thisequipment. Unauthorized changes or modifications could void the user'sauthority to operate the equipment.This device complies with Part 15 of the FCC Rules. Operation is subject tothe following two conditions: (1) this device may not cause harmfulinterference, and (2) this device must accept any interference received,including interference that may cause undesired operation.Notices xvii