73008 - DOES THE DIAGNOSTICS FINISH WITHOUT ANYERRORS? (YES, READ AHEAD. NO, GO TO STEP009.)q If the Diagnostics \ All Tests did not detect a failure butthe system still indicates a failure:q Check all adapter card jumper settings.q Check all adapter cards switch settings.q Check all adapter card cables and connectors.q Make sure that all of the above are set correctly and showthe correct voltages and continuity. Replace any defectivecables or adapter cards. See “Power Supply CableConnector Specifications” on page 129 and the layout ofsystem board according the machine type in chapter 5.q Run the Diagnostics \ All Tests again.q If an error or other symptom is displayed, go to “Index ofSymptoms, Messages, Error Codes, or Beeps” on page74.q If no error can be detected or the symptom is intermittent,go to "Undetermined Problems” on page 104.q End009 -q If the last test stops and you cannot continue, first makesure all switches, power connectors, cables, and jumpersare set correctly and show the correct voltages andcontinuity.q Take note of any messages, error codes, beeps, or newsymptoms. Go to "Index of Symptoms, Messages, ErrorCodes, or Beeps" on page 74.q If there is no error symptom or the error symptom isintermittent, go to “Undetermined Problems” on page 104.
