IBM P275 Operating Instructions Manual

Contents

IBM P275 Operating Instructions Manual Manual pdf 4 page image

2USPrecautionsInstallationDo not install the monitor in the following places:• on surfaces (rugs, blankets, etc.) or near materials (curtains,draperies, etc.) that may block the ventilation holes• near heat sources such as radiators or air ducts, or in a placesubject to direct sunlight• in a place subject to severe temperature changes• in a place subject to mechanical vibration or shock• on an unstable surface• near equipment which generates magnetism, such as atransformer or high voltage power lines• near or on a magnetically charged metal surface.• in a small space around the top, bottom and sides of the monitorthat may block the ventilation holes.Maintenance• Clean the cabinet, panel and controls with a soft cloth lightlymoistened with a mild detergent solution. Do not use any typeof abrasive pad, scouring powder, or solvent, such as alcohol orbenzine.• Do not rub, touch, or tap the surface of the screen with sharp orabrasive items such as a ballpoint pen or screwdriver. This typeof contact may result in a scratched picture tube.• Clean the screen with a soft cloth. If you use a glass cleaningliquid, do not use any type of cleaner containing an anti-staticsolution or similar additive as this may scratch the screen’scoating.TransportationWhen you transport this monitor for repair or shipment, use theoriginal carton and packing materials.Use of the Tilt-SwivelThis monitor can be adjusted within the angles shown below. Tofind the center of the monitor’s turning radius, align the center ofthe monitor’s screen with the centering mark on the stand.Hold the monitor at the bottom with both hands when you turn ithorizontally or vertically. Be careful not to pinch your fingers atthe back of the monitor when you tilt the monitor up vertically.NoteDo not remove the tilt-swivel base from the monitor.Warning on power connection• Use an appropriate power cord for your local power supply.• Before disconnecting the power cord, wait at least 30 secondsafter turning off the power to allow the static electricity on theCRT display surface to discharge.• After the power has been turned on, the CRT is demagnetized(degaussed) for a few seconds. This generates a strongmagnetic field around the metal frame, which may affect thedata stored on magnetic tapes and disks near the bezel. Placemagnetic recording equipment, tapes, and disks away from thismonitor.The equipment should be installed near an easily accessibleelectrical outlet.90°5°90°15°Centering markExample of plug types:for 100 to 120 V AC for 200 to 240 V AC for 240 V AC only