DIMM 1DIMM 2DIMM 3DIMM 4MicroprocessorClear CMOSjumper (JP 1)BIOS boot backupjumper (J 2)PTPM physicalpresencejumper (JP 10)ME recoveryjumper (JP 8)ME flash overridejumper (JP 9)TPM initializationjumper (JP 11)Low securityjumper (J 19)PIMM SPI HALF ROMenable jumper (J 12)PAttention: Before you change any switch settings or move any jumpers, turnoff the server; then, disconnect all power cords and external cables. See thesafety information that begins on page “Safety” on page vii. Do not changesettings or move jumpers on any system-board jumper blocks that are notlabelled in this document.The clear CMOS jumper does not affect the administrator password.Administrator passwordIf an administrator password is set, you must type the administrator password foraccess to the full Setup utility menu. You can use any combination of 6 - 20printable ASCII characters for the password.Attention: If you forget the administrator password, you cannot reset thepassword. You must replace the system board.Using the Boot Manager programThe Boot Manager program is a built-in, menu-driven configuration utility programthat you can use to temporarily redefine the first startup device without changingsettings in the Setup utility.To use the Boot Manager program, complete the following steps:1. Turn off the server.2. Restart the server.3. When the prompt Select Boot Device is displayed, press F12. If abootable USB mass storage device is installed, a submenu item (USBKey/Disk) is displayed.4. Use the Up Arrow and Down Arrow keys to select an item from the BootSelection Menu and press Enter.Chapter 3. Configuring the server 57
