a. Download the latest version of the UEFI code from http://www.ibm.com/supportportal/.b. Update the UEFI code, following the instructions that come with the updatefile that you downloaded.2. Update the IMM2 firmware:a. Download the latest version of the IMM2 firmware fromhttp://www.ibm.com/supportportal/ or http://www.ibm.com/support/fixcentral/.b. Update the IMM2 firmware, following the instructions that come with theupdate file that you downloaded.3. Configure the UEFI settings:a. When you are prompted to start the Configuration/Setup Utility program,restart the server and press F1.b. Select System Settings → Devices and I/O Ports.c. Select Console Redirection Settings; then, make sure that the values areset as follows:v COM Port 1: Enablev COM Port 2: Enablev Remote Console: Disablev Serial Port Sharing: Disablev Serial Port Access Mode: Disablev Legacy Option ROM Display: COM Port 1v Baud Rate: 115200v Data Bits: 8v Parity: Select any of the following three options:– None– Odd– Evenv Stop Bits: 1Attention: In Linux operating system, if the number "2" is selected forthe Stop Bits setting, the Parity setting must be set to "None".v Thermal Emulation: ANSIv Active After Boot: Enablev Flow Control: Hardwared. Press Esc twice to exit the Devices and I/O Ports section of theConfiguration/Setup Utility program.e. Select Save Settings; then, press Enter.f. Press Enter to confirm.g. Select Exit Setup; then, press Enter.h. Make sure that Yes, exit the Setup Utility is selected; then, press Enter.Using the LSI Configuration Utility programNote: OPROM configuration utility is only available for emulex 10G card.Use the LSI Configuration Utility program to configure and manage redundant arrayof independent disks (RAID) arrays. Be sure to use this program as described inthis document.v Use the LSI Configuration Utility program to perform the following tasks:66 IBM System x3250 M4 Type 2583: Installation and User’s Guide
