Note: After you reset the IMM2, this confirmation message is displayedimmediately:IMM2 reset command has been sent successfully!! Press ENTER to continue.The IMM2 reset process is not yet complete. You must waitapproximately 3 minutes for the IMM2 to reset before the IMM2 isfunctional again. If you attempt to access sever firmware informationwhile the server is resetting, Unknown is displayed in the fields, and thedescription is Error retrieving information from IMM2.LAN over USBA LAN over USB interface enables in-band communications to the IMM2; the IMM2hardware on the system board presents an internal Ethernet NIC from the IMM2 tothe operating system.Typically, the IMM2 IP address for the LAN over USB interface is set to a staticaddress of 169.254.95.118 with a subnet mask of 255.255.0.0. In the event of an IPaddress collision on the network, the IMM2 might obtain a different IP address inthe 169.254.xxx.xxx range.Because the IMM2 might obtain a random IP address for the LAN over USBinterface, the ASU and firmware flash utilities, DSA, and the IBM Systems DirectorAgent use the Service Location Protocol (SLP) to discover the IMM2 IP address.These tools perform an SLP multicast discovery on the LAN over USB interface.When they receive a response from the IMM2, they obtain the attributes thatcontain the IP address that the IMM2 is using for the LAN over USB interface.62 IBM System x3250 M4 Type 2583: Installation and User’s Guide
