Table 5. Service Processor Error Codes. (continued)Error Code Description Action/Possible Failing FRU406E 0EB6 Attention line 5 stuck fault Go to “MAP 1540: Problem Isolation Procedures”on page 124.406E 0EB7 Attention line 6 stuck fault Go to “MAP 1540: Problem Isolation Procedures”on page 124.406E 0EB8 Attention line 7 stuck fault Go to “MAP 1540: Problem Isolation Procedures”on page 124.406E 0EB9 Attention line 8 stuck fault Go to “MAP 1540: Problem Isolation Procedures”on page 124.406E 0EBA Attention line 9 stuck fault Go to “MAP 1540: Problem Isolation Procedures”on page 124.406E 0EBB Attention line 10 stuck fault Go to “MAP 1540: Problem Isolation Procedures”on page 124.406E 0EBC Attention line 11 stuck fault Go to “MAP 1540: Problem Isolation Procedures”on page 124.406E 0EBF Description: Memory errorAction:1. Reboot the system in slow mode to the SMS menus. See “Performing Slow Boot” on page 209.2. Examine the service processor error log.v If a CEC subsystem error (a 4xxx yyyy error) occurred during the slow boot that calls out thememory, processors, L3 cache modules or the primary I/O book, replace the part indicatedby the location code.v If a CEC subsystem error (a 4xxx yyyy error) did not occur during the slow boot, look for a4xxx yyyy error immediately preceding the 406E 0EBF error. Replace the part indicated bythe location code associated with that error.406E 0EE1 Service processor firmware: invalid MRU to FRUmapping 1. Check for system firmware updates.2. Call service support.406E 0EE2 Service processor firmware fault 1. Check for system firmware updates.2. Call service support.406E 0EE5 Firmware error, no callout available 1. Check for system firmware updates.2. Call service support.406F 0001 Scan interface basic assurance tests detected aCEC backplane faultCEC backplaneLocation: U0.1-P1406F 0002 CEC backplane fault 1. Check JTAG cable connections2. CEC backplaneLocation: U0.1-P1406F 0003 Scan interface basic assurance tests detectedprocessor fault 1. Check JTAG cable connections.2. Processor cardLocation: U0.1-P1-C1406F 0004 Processor fault 1. Check JTAG cable connections.2. Processor cardLocation: U0.1-P1-C2406F 000E Processor capacity card Operator PanelLocation: U0.1-L1304 Eserver pSeries 630 Model 6C4 and Model 6E4 Service Guide
