Selecting the Spanning Tree Enabled menu allows you to enable or disable the spanning tree flag. If thisflag is enabled (because the network the system is being attached to supports spanning trees), thefirmware will impose a waiting period of 60 seconds before the adapter is allowed to communicate with thenetwork. If this flag is disabled, the network adapter will be able to access the network immediately afterthe system is connected.Spanning Tree Enabled10/100 Mbps Ethernet PCI Adapter II: U0.1-P1/E11. Yes <===2. No--------------------------------------------------------------------------------------------------Navigation keys:M = return to main menuESC key = return to previous screen X = eXit System Management Services--------------------------------------------------------------------------------------------------Type the number of the menu item and press Enter or Select a Navigation key: _The Protocol option allows you to set the appropriate protocol for your network as shown below.Protocol10/100 Mbps Ethernet PCI Adapter II: U0.1-P1/E11. Standard <===2. IEEE802.3--------------------------------------------------------------------------------------------------Navigation keys:M = return to main menuESC key = return to previous screen X = eXit System Management Services--------------------------------------------------------------------------------------------------Type the number of the menu item and press Enter or Select a Navigation key: _Select the ping test option from the network parameters menu to test an adapter’s network connection toa remote system. After the ping test option is selected, the same series of screens will take you throughsetting up the IP parameters and the adapter configuration before attempting the ping test.Notes:1. After the ping test is initiated, it may take 60 seconds or longer to return a result.2. If the ping test passes or fails, the firmware will stop and wait for a key to be pressed beforecontinuing.412 Eserver pSeries 630 Model 6C4 and Model 6E4 Service Guide