IBM x3200 4362 User Manual

Also see for System x3200 4362: Installation guide Problem determination and service guide

Contents

9. If you are installing a 5.25 in. drive in bay 2, push the drive into the bay. If youare installing a 3.5 in. drive in bay 2, you must attach the 5.25 in. conversionkit to the 3.5 in. drive.Note: An optional diskette drive can be installed in bay 3.10. Determine whether the drive is an IDE or SATA device; then, connect one endof the applicable signal cable into the rear of the drive and make sure that theother end of this cable is connected into the applicable IDE or SATA connectoron the system board.11. Route the signal cable so that it does not block the airflow to the rear of thedrives or over the microprocessor and dual inline memory modules (DIMMs).12. If you have another drive to install or remove, do so now.13. Connect the power cable to the rear of the drive. The connectors are keyedand can be inserted only one way.If you have other devices to install or remove, do so now; otherwise, go to“Completing the installation” on page 42.Installing a tape driveTape driveEMC shieldFiller panelDrive retainer clipTo install a tape drive, complete the following steps:1. Read the safety information that begins on pagev and “Installation guidelines”on page 18.2. Turn off the server and peripheral devices, and disconnect the power cordsand all external cables.3. Remove the side cover (see “Removing the side cover” on page 21).4. Remove the two-piece bezel (see “Removing the two-piece bezel” on page22).30 System x3200 Types 4362 and 4363: User’s Guide