EthernetEthernet cablerelease leverCable Release TabNote: There are release levers on the Ethernet and systems managementconnectors. To disconnect a cable from one of these connectors, pull up onthe lever to release the cable.Updating the server configurationWhen you start the server for the first time after you add or remove a device, youmight receive a message that the configuration has changed. TheConfiguration/Setup Utility program starts automatically so that you can save thenew configuration settings. For more information, see the section about configuringthe server in the User's Guide on the IBM System x Documentation CDSome optional devices have device drivers that you must install. For informationabout installing device drivers, see the documentation that comes with each device.If the server has an optional RAID adapter and you have installed or removed ahard disk drive, see the documentation that comes with the RAID adapter forinformation about reconfiguring the disk arrays.If you have installed a Remote Supervisor Adapter II SlimLine to manage the serverremotely, see the Remote Supervisor Adapter ll SlimLine User’s Guide, whichcomes with the adapter, for information about setting up, configuring, and using theadapter.For information about configuring the integrated Gigabit Ethernet controller, see theUser’s Guide.Chapter 2. Installing optional devices 19
