IDS 805 Installer Manual

Also see for 805: Training manual

Contents

18IDS 805 Installer Manual 700-266-02H Issued September 2009LOCATION 11 Tamper per Zone EnabledValue Action0 Default Disabled1 EnabledSee Section 3: End-of-Line Resistors/ Tamper per Zone for the correct use of tamper per zone.LOCATION 12 Arming OptionsValue Quick Arm Entry/Exit Delaywith Arm Zone Forced Arming Engineer Reset0    1 Default    2    3    4    5    6    7    8    9    10    11    12    13    14    15     Enabled DisabledThe quick arm option allows the user to arm the panel by holding down the [1] key until the keypadbeeps. Using the quick arm key initiates an arming cycle as if a valid user code has been entered. Usercode 1 will be reported if the quick arm key is used.The key-switch exit delay option enables or disables entry/ exit delays with key-switch arming. SeeSection 5 in the User Manual for information pertaining to key-switch arming.Forced arming allows the panel to arm with violated zones e.g. an open window. Once the panel arms, aviolated zone will bypass automatically. If a zone which has been automatically bypassed clears while thepanel is armed, the zone will become active i.e. the window is pushed closed. Opening the window againwill cause an alarm condition to be registered.