IDS IDS805 User Giude

Also see for IDS805: Installer manual Quick start guide

16 IDS805 USER MANUAL NO. 700-266-01A ISSUED NOV 2003 VER 1.00IDS805 USER MANUAL! If the entry period is too short, have your installer change theentry delay period.! If four incorrect user codes are entered consecutively while eitherarming or disarming the system, the keypad will be non-responsive for 30 seconds. Your monitoring company will also benotified on a keypad tamper.NOTE:If the ARMED indicator is flashing upon entry, there has been aviolation. The intruder may still be inside! Call for assistance.NOTE:If a strobe (or flashing light) has been installed and an alarm conditionis registered the light will continue flashing after the siren has stoppedsounding. Entering a valid [USER CODE] will cancel the strobe.7.2 To Disarm with a Key-Switch or Remote Control1. Press the remote button or twist and release the key-switch.2. The system will disarm and the remote indicator (if installed) willextinguish.3. If programmed to do so, the siren will sound briefly - verify withyour installer.8. Emergency Situations8.1 Fire Alarm[F](Hold down the key until the keypad buzzer sounds)! If the [F] key is pressed until the keypad beeps (approximately 1second) a FIRE ALARM condition will be activated.! The FIRE ALARM CONDITION can also be triggered by a smokedetector connected to an appropriately programmed zone.! The siren will sound and the FIRE REPORTING CODE will betransmitted to the monitoring company.! To silence the siren enter a 4 digit [ USER CODE ]. The siren willstop sounding after 10 minutes if no user code is entered.