IHP CAPELLA 33 Installation And Operation Instructions Manual

Also see for CAPELLA 33: Installation and operation instructions

Contents

IHP CAPELLA 33 Installation And Operation Instructions Manual Manual pdf 6 page image

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.6MANUAL CONTROL PANEL OPERATION(refer to Figures 4 & 5)Once this appliance has been properly installedand connected to the power supply as defi nedin this manual, it is ready to operate.Note: Ensure the circuit breakers for the powersupply are turned on.This appliance can be operated either from themanual control panel (see Figures 4 & 5) orby using the remote control, wall switch or wallthermostat (optional kits).The manual controls are located on the fi reboxfl oor on the front left (see Figure 5). If anoptional glass enclosure is installed, it mustbe removed to access.Main Power ON/OFF SwitchWhen the main power switch is turned on, poweris supplied to the fi replace. This switch must beon for all other switches to operate.Heater ON/OFF SwitchWhen this switch is turned on, the heater willemit heat in the temperature range selected (seeFigure 6; G, H & I). The fi replace can operatewith or without heat.Flame / Ember On/Off Switch:Turns lights on inside ember bed and fl amecylinder.MANUAL CONTROL PANELMain Power On/Off (rear most switch)Figure 4FINAL FINISHINGMaterials such as brick and tile can be extendeddown to the top of the fi replace. Do not extenddown, covering the outlet or glass enclosurepanel (optional kit).There are a wide variety of “fi nished looks” forthese fi replaces, from formal wall decor withelaborate mantels to rustic wood paneling orwarm brick facings.Accent Trim InstallationsAn optional accent trim kit is available from yourdealer (see Page 18). These options give theappliance an attractive finished look.HearthAn aesthetically pleasing fi replace hearth canbe installed, if desired (see hearth protectionon Page 5).BREAK-IN PERIODDuring the fi rst few initial uses of this heater,there may be a release of a slight, harmlessodor. This odor is a normal occurrence causedby the initial heating of the internal heatingelements and should not reoccur.Flame / Ember On/Off (front most switch)Manual Control Switchesare located behind pullscreen on inside floorFigure 5OnOnOn OffOffOff• When using the main power on/off switchinside the manual control panel, the poweron/off switch outside the manual controlpanel (optional wall switch kit) must be inthe OFF position.• When using power on/off switch outsidethe manual control panel (optional wallswitch), the power on/off switch inside themanual control panel must be in the OFFposition.• When using the remote control, the poweron/off switch inside the manual controlpanel and the wall switch (optional kit)must be on the OFF position.Heater On/Off (center switch)