Attenuator functionThe attenuator prevents a desired signal from distorting whenvery strong signals are near the desired frequency or whenvery strong electric fields, such as from a broadcasting sta-tion, are near your location.➥ Push [ΩΩΩΩ ATT] for 1 sec. to toggle the attenuator functionON and OFF.• “ATT” appears when the attenuator function is in use. RF gainThe receiver gain can be reduced with the RF gain setting.This may help to remove undesired weak signals while mon-itoring strong signals. The RF gain may be useful for setting aminimum level at which to hear signals for SSB/CW modes .➥ Push [≈≈≈≈ RF GAIN] for 1 sec. to enter the RF gain set-ting condition, then rotate [R-DIAL] to select the desiredRF gain level.• Normally this setting is used maximum level.• Push [DUALWATCH] to exit the RF gain setting condition.SET-RF-GAIN:MAX√MODE ANLAFCTSQLUSB14 120PSKIP-DUPSET-RF-GAIN:5√MODE ANLAFCTSQLUSB14 120PSKIP-DUPMaximum levelSetting level5[R-DIAL]RF GAINATT√MODE ANLAFCTSQLFM146 010PSKIP-DUPATTDIAL.SEL SWEEP CENTERT-SCAN SKIP M.NTONE SET TSATT RF GAIN IC Recorder1 2 34 5 6 07 8 9BANDDUALWATCH MAIN/SUB POWERVFOMHz MODESCAN MRS.MWSCOPELOCKRECAFC“ATT” appears while theattenuator functions is inuse.194 BASIC OPERATION
