6311 OTHER FUNCTIONSD Cloning error NOTE: DO NOT push any key on the sub-receiver duringcloning. This will cause a cloning error.When the display appears as below, a cloning error has oc-curred.In such a case, the receiver automatically performs ALLRESET while turning power OFF and ON. Auto power-off functionThe IC-R20 can be set to automatically turn OFF after a spec-ified period in which no operation is performed.BUSY, 120 min., 90 min., 60 min., 30 min. and OFF can bespecified. The specified period is retained even when the re-ceiver is turned OFF by the auto power-off function. To cancelthe function, select “OFF” in step e below.q Push [8 SET] for 1 sec. to enter set mode.wRotate [R-DIAL] to select “AUTO POWER OFF” item, thenpush [8 SET].• Turn the expanded set mode ON for selection. (p. 49)eRotate [R-DIAL] to select the desired time or to turn thefunction OFF, then push [8 SET].r Push [DUALWATCH] to exit set mode.***-SET-MODE-***-SCAN-PAUSE>AUTO-POWER-OFF-MONITOR----------------AUTO-POWER-OFF>BUSY-120MIN-90MIN-60MIN-30MIN-OFF----------------[R-DIAL]DUALWATCHSET8USING EXPANDED SET MODE√MODE ANLAFCTSQLFM146 010PSKIP-DUPALL-RESETCLONE-ERRORTurn power OFF, then ON
