Icom IC-R75 Instruction Manual

Also see for IC-R75: Price list Instruction manual Instruction manual Service manual

Icom IC-R75 Instruction Manual Manual pdf 13 page image

■ Tape recorder connections■ Transceive function93INSTALLATION AND CONNECTIONSPL-259 CONNECTOR INSTALLATION EXAMPLE30 mm10 mm (soft solder)10 mm1–2 mmsolder solderSoftsolderCoupling ringSlide the coupling ringdown. Strip the cablejacket and soft solder.Slide the connectorbody on and solder it.Screw the coupling ringonto the connectorbody.Strip the cable asshown at left. Softsolder the center con-ductor.(10 mm ≈ 3 ⁄8 in)qwer■ Antenna connectionAntennas play a very impor tant role in receiveroperation. Connecting a poor quality antenna to thereceiver will result in less than optimum performance.When using a 50 Ω antenna, use [ANT 1] connectorfor connection. When using a 500 Ω long wireantenna, use [ANT 2] terminal for connection.The [REC OUT] jack has 350 mV rms/4.7 kΩ outputfor connection to other audio equipment.[REC REMOTE] jack: Grounds when a signal isreceived and squelch opens. If a tape recorderhas a control terminal, this jack can be used forrecording control. (1 A/DC max.)[RECREMOTE][REC OUT]350 mVrms4.7 kΩ[AUX IN] or[LINE IN] jackIC-R75Icom CI-V transceivers or receivers can be connectedvia the [REMOTE] jack. The frequency and modebecome the same* when either radio is changed.* When a set frequency is out-of-range for one of theconnected transceivers or receivers, the connectedradio’s frequency/mode does not change.[REMOTE]IC-R75Icom CI-V transceiver/receiverConnect to [REMOTE] jackBe sure the “CIV TRn” item is turned ON in set mode (p. 32).