Icom IC-T7H Instruction Manual

Also see for IC-T7H: Instruction manual Service manual

ADVANCED FUNCTIONS 415D Programming during selection➀ Push [VFO] to select VFO mode.➁ Set the desired frequency:➥ Set other data, such asrepeater information, etc. usingset mode if required.➂ Push [S.MW] momentarily.• “X” flashes.• Do not hold [S.MW] for more than 1sec., otherwise the memory channelwill overwrite the displayed number.➃ Rotate [DIAL] to select the desiredchannel.• Call channel and scan edge channels,as well as regular memory channels,can be programmed in this way.• If you want to confirm the VFO fre-quency, push [S.MW] momentarily.➄ Push [S.MW] for 1 sec. to program.• “X” stops flashing.DL O WUPDL O WUPDL O WUPDL O WUPMRMR Memory/call channelsThe transceiver has 70 memory channels (60 regular, 4 pairsof scan edge channels for mixed bands and 1 call channel foreach band). Note that memory channels are not groupedaccording to band. In other words, a given memory channelcan be programmed with either a VHF frequency or a UHFfrequency. This is not the case with call channels. Call chan-nels are band specific.The following can be programmed into memory/call channels:• Operating frequency• Duplex direction with an offset frequency (pgs. 13, 14)• Subaudible tone encoder or tone squelch ON/OFF with atone (CTCSS) frequency (pgs. 21, 22)• Skip information (p. 20)