iiUNPACKINGAccessories included with the transceiver: Qty.q Antenna............................................................................1w Handstrap ........................................................................1e Battery pack (BP-173/BP-180) or battery case (BP-170)attached to the transceiver ..............................................1r Belt clip ............................................................................1t Wall charger*....................................................................1*Not supplied with battery case versions.Antenna for U.S.A. version differs from that shown above.DO NOT push the PTT when not actually desiring totransmit.DO NOT operate the transceiver near unshielded electri-cal blasting caps or in an explosive atmosphere.AVOID using or placing the transceiver in direct sunlight orin areas with temperatures below –10°C (+14°F) or above+60°C (+140°F).Place unit in a secure place to avoid inadvertent use by chil-dren.The use of non-Icom battery packs/chargers may impairtransceiver performance and invalidate the warranty.Even when the transceiver power is OFF, a slight current stillflows in the circuits. Remove the battery pack or case fromthe transceiver when not using it for a long time. Otherwise,the battery pack or installed dry cell batteries will becomeexhausted.For U.S.A. onlyCAUTION: Changes or modifications to this device, notexpressly approved by Icom Inc., could void your authority tooperate this device under FCC regulations.➀ ➁ ➂ ➃➄