Icom IC-T7H Instruction Manual

Also see for IC-T7H: Instruction manual Service manual

4 ADVANCED FUNCTIONS16D Programming after selection➀ Select the memory channel to be programmed:➥ Push [MR] to select memory mode.➥ Rotate [DIAL] (or use the keypad) to select the memo-ry channel.• Non-programmed channels cannot be selected.➁ Set the desired frequency in VFO mode:➥ Push [VFO] to select VFO mode.➥ Set the desired frequency using the keypad or [DIAL].➥ Set other data, if desired.➂ Push [S.MW] for 1 sec. to program.D Memory/call ➾ VFO➀ Select the memory/callchannel to be transferred:➥ Push [MR] (or [CALL])to select memory (call)mode.➥ Rotate [DIAL] (or usethe keypad) to selectthe memory channel.➁ Push [S.MW] for 1 sec. totransfer to VFO.D Memory/call ➾ call/memory➀ Select the memory/call channel to be transferred:➥ Push [MR] (or [CALL]) to select memory (call) mode.➥ Rotate [DIAL] (or use the keypad) to select the memo-ry channel.➁ Push [S.MW] momentarily.• A beep sounds, “VF” appears and “X” flashes.• Do not hold [S.MW] for more than 1 sec., otherwise the memorychannel will overwrite the VFO.➂ Rotate [DIAL] to select a memory or call channel to trans-fer the data.➃ Push [S.MW] for 1 sec. to program.• “X” stops flashing.D Memory clear➀ Push [S.MW] momentarily.➁ Select the memory channel to be cleared with [DIAL].➂ Push [S.MW] briefly, then a second time for 1 sec.• 3 beeps sound, then the frequency is cleared.• “X” flashes continuously.• Scan edges 1A and 1B and call channels cannot be cleared.➃ Push [(VFO) CLR] to stop the flashing.NOTE: Be careful — the contents of cleared memoriesCANNOT be recalled.DUPDUPVFO mode selectedfor1 sec. Memory modeMWS.MWD