10 GPS/GPS-A OPERATION10-26GPS Logger function (Continued)■D Turning ON the GPS Logger functionTurn the GPS logger function ON or OFF, to store yourroute as you move.When the GPS Logger function is set to ON, the trans-ceiver stores the position data from GPS receiver intomicroSD card in a specified time interval.While using the Internal GPS receiver only four GPSsentences, GGA, RMC, GSA and VTG, are used.Push [MENU]q .Push D-pad(w ) to select the root item (“GPS”), andthen push D-pad(Ent) to go to the next screen.D-pad(�)(Ent)(MENU > GPS > GPS Logger > GPS Logger)Refer to the menu sequence shown directly above,eand push D-pad() to select, and then D-pad(Ent)to enter, one or more times until the last screen isdisplayed.Push D-pad(r ) to select “ON.”Push [MENU]t to exit the Menu screen.• The GPS Logger starts.NOTE:While using the external GPS receiver, uses only thecompatible GGA, RMC, GSA and VTG sentences.D Setting the GPS record intervalFor example, when you are walking and if the time in-terval is set to “1sec,” a lot of position data is storedat almost same place. Select the GPS Logger functionrecord interval to suit your travel speed. (Default: 5sec)Push [MENU]q .Push D-pad(w ) to select the root item (“GPS”), andthen push D-pad(Ent) to go to the next screen.D-pad(�)(Ent)(MENU > GPS > GPS Logger > Record Interval)Refer to the menu sequence shown directly aboveeand push D-pad() to select, and then D-pad(Ent)to enter, one or more times until the last screen isdisplayed.Push D-pad(r ) to select a desired record interval.• Selectable settings are 1, 5, 10, 30 or 60 seconds.Push [MENU]t to exit the Menu screen.GPS LOGGER screenRecord Intervalscreen* The transceiver has an exclu-sive GPS logger mode whereonly the logger is functioning.See page 10-29 for details.Select*
