JBL MA7100HP Owner's Manual

MA7100HP | MA9100HP Owner's Manual | rev1.3 20240612 Pg 25 of 45©2024 Harman International | Features, Specifications, and Appearance subject to change without notice.Speaker Distances – Calibration settings for the distances between the loudspeakers and the listening position.NOTE: Speakers that are not present in your configuration will be greyed out⃞Units – Select how you wish to measure distances in imperial or metric units, or in milliseconds. As described in“Essential Setup” (see Essential Setup). Measure the distance from each loudspeaker in your system to your ear in themain listening position and enter the values. This allows the Receiver to calculate the correct relative delay for eachloudspeaker.Speaker Level - These settings allow adjustment of individual speaker levels. They should be adjusted using eitherinternally generated test noise or an external source, such as a setup test disc.NOTE: Speakers that are not present in your configuration will be greyed out⃞Test Tone – Selects the internal test tone generator or allows the use of an external test tone form the currentlyselected input source (e.g. BD player in HDMI source).Use the  and  navigation buttons on the remote control to select the relevant speaker. Use the  and  navigationbuttons to adjust the noise level from each speaker.As described in “Essential Setup” (see Essential Setup), adjust the level of the test noise from each speaker so that an SPLmeter at the listening position measures 75dB SPL.Speaker Crossover - This is the frequency below which signals are filtered away from these Small speakers and redirectedto ’Large’ speakers or the subwoofer (if present). 80 Hz is usually the best crossover frequency, since it sends non-directionallow frequencies to the subwoofers which are best suited to handle low frequencies and can be placed optimally to reproduceonly the lowest frequencies.Zone2 Line Out – Select “Party On” to route the Main Zone to the Zone 2 line-level output. Party mode follows the MainZone, i.e. a stereo downmix of the same source as currently selected in the Main Zone.When Party is selected for either the Line Out or Rear Configuration Amp Assignment, you will have the option to enter theParty Mode settings from the Main Menu as shown below, which provides an independent volume control.