22 englishJabra GO 6470 User manUalto connect the Jabra GO base to an electronic hookswitch port:1. make sure that you have purchased the correct electronic-hookswitch adapter for your desk phone modelfrom Jabra.2. Connect the electronic-hookswitch adapter as described in the cabling guide included with the adapter.3. Configure the Jabra GO base to communicate correctly with your model of desk phone. the required standardis clearly printed on a label attached to the hookswitch cable. the touchscreen setup wizard will automaticallyask for this during initial setup; see also Section 8.9: Re-running the Setup Wizards for instructions about how tomake this setting at any time after the initial setup.4. Check the documentation for your desk phone to see which (if any) steps are required to configure your deskphone to use the electronic switch. Check also for updates to your phone’s firmware.connecting the JabRa go baSe to youR coMPuteR4.7all Jabra GO models can be connected to a computer via a Usb cable for the purposes of configuration andfirmware updates. In addition, the Jabra GO 6470 model can use this connection to interact with a softphoneprogram.Figure 14: Connecting to a computerto connect the Jabra GO base to your computer:1. Connect the small connector of the supplied Usb cable to the port marked on the Jabra GO base.2. Connect the other end of the Usb cable to any free Usb port on your computer.3. Install the Jabra pC suite software on your computer (see Chapter 5: Installing and Running the Jabra PC Suite).PaiRing youR headSet with a Mobile Phone4.8the Jabra GO headset can be used with any mobile phone that supports bluetooth. you must set up the wirelesscommunication between the two devices by pairing them. the setup wizard helps you to do this during initialsetup and can repeat the procedure at any time later. see Section 7.4: Using the Headset with Other BluetoothDevices for details.