Jabra GO 6470 User Manual

Also see for GO 6470: User manual Datasheet Brochure How do Datasheet

Contents

Jabra GO 6470 User Manual Manual pdf 33 page image

33 englishJabra GO 6470 User manUalAttaching the Head- or Neckbandto attach the head- or neckband:1. remove the current wearing-style attachment, if any.2. align the earbud and fitting of the headset with the matching holes on the head- or neckband and press untilit clicks into place.3. put on the headset and rotate the microphone until it is as close as possible to your mouth.Figure 26: Attaching the Jabra GO headset to a head- or neckbandRemoving a Wearing-Style Attachmentto remove a wearing-style attachment, perform the opposite procedure to that described above for attaching it.RePlacing the eaRbud7.3after extensive use, the earbud of the Jabra GO headset may become worn, dirty and/or uncomfortable. twoextra, differently shaped earbuds are included with your headset. Otherwise, you can order replacement earbudsfrom Gn at any time.to remove the earbud, hold the headset with the earbud facing you and twist the earbud gently anti-clockwiseuntil it comes free. then align the replacement earbud onto the same fitting and gently press it down until itclicks into place (do not rotate).uSing the headSet with otheR bluetooth deviceS7.4Pairing the Headset with a Mobile Phoneto use bluetooth, you must set up the wireless communication between the Jabra GO headset and your mobilephone by pairing them. the setup wizard helps you to do this during initial setup, but can also pair the headsetmanually at any time using the procedure below.1. If your headset is currently turned on, turn it off by pressing and holding on its multifunction button for about4 seconds — until its led gives four quick flashes and then turns off.2. put your (powered-off ) headset in pairing mode by pressing and holding on its multifunction button for about4 seconds — until its led lights a constant blue.4 sec.4 sec.