56 englishJabra GO 6470 User manUalPaiRing the adaPteR and headSet10.4to pair your Jabra GO headset and Jabra lInK 350 Usb bluetooth adapter:1. attach the Usb bluetooth adapter to your pC and turn on the pC (see also the section 10.3: Jabra LINK 350 USBBluetooth Adapter Setup and Connection).2. put the Usb bluetooth adapter in pairing mode by pressing and holding its multifunction button for about 2seconds — until its blue pairing led turns on and stays lit.3. If your headset is currently turned on, turn it off by pressing and holding on its multifunction button for about4 seconds — until its led gives three quick red flashes and then turns off.4. put your (powered-off ) headset in pairing mode by pressing and holding on its multifunction button for about4 seconds — until its led lights a constant blue.5. place the headset close to the Usb bluetooth adapter and wait for a few seconds. when pairing is successful,you will see the following indicators:- On the adapter: the led flashes blue quickly five times and turns off.- On the headset: the led flashes blue five times and then turns off.6. your headset and Usb bluetooth adapter are now paired and connected.Figure 47: Jabra GO headset paired with both a mobile phone and the Jabra LINK 350 USB Bluetooth AdapterJabRa link 350 uSb bluetooth adaPteR viSual indicatoRS10.5the Jabra lInK 350 Usb bluetooth adapter includes a pair of closely spaced leds, which light in various colorsand patterns to indicate the status of the adapter and its connections. these are summarized in the table below.Adapter Status LED SignalConnected and ready for use, softphone is current target Constant greenConnected and ready for use, softphone is not current target Constant yellowpaired but not connected slow-flashing greenpairing mode Constant bluepairing succeeded Quintuple (5x) blue flash (displays once)Online moderate blue flashringing triple blue flashmuted Constant redVisual signals of the Jabra LINK 350 USB Bluetooth Adapter and their meaningsTable 7: