MOTORSERVICE ACCESS (WITH INTEGRAL SKIRT)REMOVABLE SKIRTACCESS PANELS ACCESS AREAReinstalling PanelHold at an angle to the skirt and insert clip under edgeof skirt opening. Bow the panel outward and insert clipon other side.BOWACCESSPANELSKIRTACCESSPANEL20"36"24"18" BACSERVICE ACCESS (CORNER BATH WITHOUT SKIRT)A - Preferred accessB - Acceptable alternative if access A is not possibleC - Optional access for accessory equipmentRIGHT HAND UNIT SHOWNNOTE: Left hand unit access is on the oppositeside (mirror Image).Service AccessFor partially or fully sunken installations, allow foraccess to service connections. It is the installer's re-sponsibility to provide sufficient service access. Therecommended minimum dimensions allowable for ser-vice to the bath are shown in the "Service Access" illus-tration.Provide adequate area around unit for air circulationfor cooling the motor and to supply sufficient air to thejets. Do not insulate this area or around motor.Service Access with SkirtAn optional skirt fits along the side of the bath forabove-floor installations and is also an access panel forservicing. Allow a space of at least 8 inches away fromthe bath for skirt removal.The skirt is designed to accommodate the addedheight of the tile, linoleum, or other floor coverings up to1-1/4 inches above the floor, and will be flush with thefloor when installed.More detailed instructions on skirt installation are pro-vided with the optional skirt assembly.Service Access with Integral SkirtService access is through the removable skirt panels.INSTALLATIONMOTOR18"18"12"12"PREFERREDACCESSALTERNATEACCESSSERVICE ACCESS (WITHOUT SKIRT)6Jacuzzi Whirlpool Bath© U961000F 12/04Or slide clips over bottom lip of skirt opening and tiltup until velcro tabs make contact.ACCESSPANELSKIRTACCESSPANEL