Jacuzzi Espree Series Installation And Operating Instructions Manual

Contents

Jacuzzi Espree Series Installation And Operating Instructions Manual Manual pdf 12 page image

Drain InformationA drain/overflow assembly (sold separately) must beinstalled on the bath, water tested, and connected tothe sanitary system of the house. After opening thecarton, inspect for damage and verify that the kit is ofthe proper finish. In the Jacuzzi Whirlpool Bath drain/overflow kit, note that the waste flange, strainer, over-flow cover and cover screws are packaged in a sepa-rate package within the kit to protect the trim finish.Follow the installation instructions provided with thedrain/overflow kit. After the drain is fully installed, testfor proper drainage. If the unit does not drain properly,rectify this condition before proceeding with the instal-lation. Jacuzzi Whirlpool Bath is not responsible forremoval and or reinstallation costs.NOTE: Watertight installation of the drain is theinstaller's responsibility. Drain leakage is excludedfrom the Jacuzzi Whirlpool Bath warranty of thisproduct.PlumbingPump, jets, and suction fittings for the whirlpool sys-tem are factory plumbed in schedule 40 PVC piping.All Jacuzzi Whirlpool Bath products are factory testedfor proper operation and watertight connections prior toshipping. If leaks are detected, notify your Jacuzzi Whirl-pool Bath Dealer. Do not install the unit.Water SupplyConsult local authorities for plumbing code require-ments in your area.IMPORTANT: Proper installation of the fill spoutplumbing and compliance with local codes are theresponsibility of the installer. Jacuzzi WhirlpoolBath does not warrant connections of water supplyfittings and piping, fill systems, or drain/overflowsystems. Nor is it responsible for damage to thebath which occurs during installation.CAUTION: A nonflammable protective barrier mustbe placed between soldering work and bath unit toprevent damage to the bath.Clean-Up After InstallationTo avoid dulling and scratching the surface of the bath,never use abrasive cleaners. A mild liquid detergentand warm water will clean soiled surfaces.Remove spilled plaster with a wood or plastic edge.Metal tools will scratch the surface. Spots left by plas-ter or grout can be removed if lightly rubbed with deter-gent on a damp cloth or sponge.Paint, tar, or other difficult stains can be removed withpaint thinner, turpentine, or isopropyl alcohol (rubbingalcohol).Minor scratches which do not penetrate the color fin-ish can be removed by lightly sanding with 600-grit wet/dry sandpaper. You can restore the glossy finish to theacrylic surface of the bath with a special compound,Meguiar's #10 Mirror Glaze. If that is not available, useautomotive rubbing compound followed by an applica-tion of automotive paste wax.Major scratches and gouges which penetrate theacrylic surface will require refinishing. Ask your JacuzziWhirlpool Bath dealer for special instructions.INSTALLATION8Jacuzzi Whirlpool Bath© U961000F 12/04