Jacuzzi Espree Series Installation And Operating Instructions Manual

Contents

Jacuzzi Espree Series Installation And Operating Instructions Manual Manual pdf 11 page image

Electrical Connection 6060 With HeaterOn the 6060 with integral skirt, one junction box hasbeen provided for the pump/motor and one for the heater.To access, remove skirt access panel. See top view forlocation.A separate GFCI protected outlet (not provided) is re-quired for pump/motor and is to be installed in the junc-tion box. The junction box is to be hard wired. Themotor is bonded to the junction box at the factory.Install a separate 120 VAC 15 AMP dedicated circuitwith GFCI protection. With a #8 solid copper wire, bondthe heater to the house electrical panel or approved lo-cal bond. A bonding lug is provided on the heater.At initial start-up and before each use thereafter withpower ON, push the GFCI test button. The reset buttonshould pop out. Push this button in to reset. If the inter-rupter fails to operate in this manner, there is a groundcurrent flowing or a device malfunction, indicating thepossibility of electrical shock. Turn off power and donot use the bath until the source of the problem hasbeen identified and corrected.Electrical ConnectionsA separate circuit, which must be protected by aGround Fault Circuit Interrupter (GFCI), is required.Install a duplex outlet to the studwall underneath thebathtub, at least 4 inches above the floor. The duplexoutlet is not provided. Because these units are manu-factured with a safe, convenient Magic Touch whirlpoolON/OFF switch on the bath itself, no remote switch ortimer is necessary. If an optional timer is desired, oneis available from Jacuzzi Whirlpool Bath for 115 VACoperation.DANGER: RISK OF ELECTRIC SHOCK. Connectonly to a circuit protected by a Ground Fault CircuitInterrupter.CAUTION: Operating the motor/pump withoutenough water in the bath can cause leaking and per-manent damage to the pump. Before power is ap-plied to the installation, make sure the switch is inthe OFF position to avoid pump damage.ELECTRICAL CONNECTION(FOR SIDE/END DRAIN BATHS)DUPLEXRECEPT.*3 PRONGPLUG4" MIN.*(NOT PROVIDED)FLOORINSTALLATIONELECTRICAL CONNECTION(FOR MOTOR PUMP ON DRAIN SIDE)3 PRONGPLUGDUPLEXRECEPT.**(NOT PROVIDED)FLOOR4" MIN.OR INACCORDANCEWITH LOCALBUILDING ORELECTRICALCODESGFCIBONDING TO PUMP/MOTORPOWER CORDTO MOTOR60x60 WITH INTEGRAL SKIRTMOTOR JUNCTION BOXGFCIBONDING TO RAPIDHEATPOWER CORDTO RAPIDHEAT60x60 WITH INTEGRAL SKIRTRAPIDHEAT JUNCTION BOXPUSH TO RESETOVER HEATPROTECTIONHEATER ON7Jacuzzi Whirlpool Bath© U961000F 12/04