Page 63J-400 Series6. Once back to the “Program B” MainMenu, press the Down button on theQuad keypad to highlight “StartTime” (Figure K). Press the Left orRight button on the Quad Keypad toselect the time you wish the spa torun. Press the Down button onkeypad to save setting.note: If you are using a standard 12-hour period, you will seethe hour displayed as “1PM”. For the 24-hour period it will read “1300”.7. Now you will need to adjust the“Duration” (Figure N) of the cycle.The duration range is from 0 (OFF)to 6 hours. Press the Left or Rightbutton on the Quad Keypad to makeyour adjustment(s) in increments of 1hour.note: The default “Duration” is OFF.8. Press the Splash button on the Quad Keypad to get back to theHeating Menu.9. Press button D to exit the HeatingMenu and return to the Settings 2Main Menu. If you haveprogrammed both heating cyclesand the settings have beenaccepted, you will see the twoprogram icons next to word Heatingon the display (Figure O). If onlyone cycle was programmed, there will only be one icon. Ifno cycles were programmed there would be a thermometer withwavy arrows as the icon.13.4 Clean-up “blow-out” CycleThe clean-up cycle is once per day in both Auto-Heating andProgrammable modes at 12:00 (noon) for two minutes. This is not userprogrammable. Each jets pump activates for one minute to circulate anywater in the plumbing unless a pump has just finished a 20 minute timeout, it will not automatically activate for the clean-up cycle. Be aware, thefactory programmed clean-up cycle cannot be canceled or altered!PROGRAM BStartTimeDay SettingsDurationSelectBStart TimePress to save1AMFigure KPROGRAM BStartTimeDay SettingsDurationSelectBPress to enterDuration OFFFigure NPrimarySecondaryHeatingPress toreset to defaultSETTINGS 2OFFA BFigure O
