Jenn-Air FREESTANDING OUTDOOR GRILLS Installation Instructions And Use & Care Manual

Contents

334. After inspecting the inside of burner for blockage,reassemble burner by sliding the middle tube of the gasburner over the gas orifice.5. Reattach gas burner using 2 screws.INFRARED SEAR BURNERCleaning Method:1. Light the infrared sear burner. See the “Lighting the Grill, Searand Side Burner” in the “Using Your Outdoor Grill” section.2. Turn knob to HI and close the sear burner cover.3. Leave the burner on high for approximately 30 minutes.4. Turn knob to OFF and let cool completely.5. Remove grill grate and brush off ash particles from the searburner cover plate.6. Replace grill grate.GRIDDLE/SIDE BURNERCleaning Method:■ Clean the exterior of the burner with a wire brush.■ Clear any clogged burner ports with a straightened paperclip.■ Do not use a toothpick as it may break off and clog the port.■ Check and clean burner/venturi tubes.1. Remove grill grates and flame tamers.2. Remove the 2 screws that hold the burner in place.Remove gas burner from the grill.3. Use a flashlight to inspect into the burner through theburner inlet to ensure there is no blockage. If anyobstruction is seen, use a metal coat hanger that hasbeen straightened to clear them.4. After inspecting the inside of burner for blockage,reassemble burner by sliding the middle tube of the gasburner over the gas orifice.5. Reattach gas burner using 2 screws.ROTISSIERE BURNERCleaning Method:1. Light the rotisserie burner. See the “Using Your RotisserieBurner” section.2. Close the grill hood.3. Leave the burner on high for approximately 30 minutes.4. Turn knob to OFF and let cool completely.5. Brush off ash particles from the rotisserie burner.DRIP TRAYIMPORTANT: The drip tray should only be removed when grill iscompletely cool.The full-width drip tray collects grease and food particles that fallthrough the grill. Clean often to avoid grease buildup.Cleaning Method:■ Remove tray and set on a flat surface.■ Wipe excess grease with paper towels.■ Mild detergent and warm water. Rinse and dry thoroughly.■ Replace tray.KNOBS AND FLANGE AREA AROUND KNOBSIMPORTANT: To avoid damage to knobs or flange area aroundknobs, do not use steel wool, abrasive cleaners, or oven cleaner.Do not soak knobs.Cleaning Method:■ Mild detergent, a soft cloth and warm water.■ Rinse and dry.A. Burner/orifice connectionAA. Burner/orifice connectionA