Jenn-Air JMW2430 Use & Care Manual

Also see for JMW2327: Use & care guide Use & care guide Use & care guide Use and care guide Use & care guide

10OVEN USEOdors and smoke are normal when the oven is used the first fewtimes, or when it is heavily soiled.During oven use, the heating elements will not remain on, but willcycle on and off throughout oven operation.IMPORTANT: The health of some birds is extremely sensitive tothe fumes given off. Exposure to the fumes may result in death tocertain birds. Always move birds to another closed and well-ventilated room.Aluminum FoilIMPORTANT: To avoid permanent damage to the oven bottomfinish, do not line the oven bottom with any type of foil or liner.■ For best cooking results, do not cover entire rack with foilbecause air must be able to move freely.■ To catch spills, place foil on rack below dish. Make sure foil isat least ½" (1.3 cm) larger than the dish and that it is turnedup at the edges.Positioning Racks and BakewareIMPORTANT: To avoid permanent damage to the porcelainfinish, do not place food or bakeware directly on the oven door orbottom.RACKS■ Position racks before turning on the oven.■ Do not position racks with bakeware on them.■ Make sure racks are level.Depending on the oven model, you could have flat, offset and/orroll-out racks. If “f” is after the rack position, the flat rack shouldbe used. An “o” after the rack position indicates the offset rackshould be used. An “r” indicates the roll-out rack should be used.For example: 1o, 3f, 5r indicates the use of the offset rack in rackposition 1, the flat rack in position 3, and the roll-out rack inposition 5. Refer to the section for the mode you are using forspecific rack recommendations.30” (76.2 cm) Rack PositionsBAKEWARETo cook food evenly, hot air must be able to circulate. Allow2" (5.0 cm) of space around bakeware and oven walls.Roll-Out RackThe roll-out rack allows easy access to position and remove foodin the oven. The roll-out rack will fit in all positions.Open PositionClosed and Engaged PositionTo Insert Roll-Out Rack1. Angle rack assembly up and insert into the “V” cutout in therack guides of the oven cavity.2. Keep rack lifted up at an angle and push in to bypass thelower “V” cutout.3. Gently slide rack into oven, bypassing the “V” cutouts.12345A. Slide railsB. Sliding shelfA. Slide railsB. Sliding shelfA. Rack guideB. “V” cutoutABBAAB