Jenn-Air Jenn-Air Service Manual

Also see for JENN-AIR: Use and care guide

Contents

6Anchor the Unit (Optional):If you are attaching the unit to cabinetry, drill three 3/16" holesthrough both outer trims. Drill 1/8" pilot holes into the cabinetry.Install screws.Additionally: If the depth/height of opening is excessive usesteel hanger strap. Double over strap at the achor points tosecure cabinet.Adjust door hinges:Check to make sure the doors are properly adjusted. If not,adjust the top hinges. The hinges are slotted for side to sidemovement. Remove and discard the small phillips screw onthe door hinge, which is located on the hinge. Adjust the tophinges by loosing the 3 large Torx screws. Tighten the screwsafter the doors are adjusted. Extruded door handles can beadjusted for alignment by loosening the screws under themagnetic backed molding (See fig. 8a).Drill 3 holes throughvertical frame intocabinetry. Whereapplicable.(approx. location)Installing Side Panels:Optional side panels need to be 1/4-inch thick.Slide panel into position and secure with screwsindicated by the shaded area (Fig. 11a). A 3/16-inchbatten is required between the cabinet and sidepanel (Fig. 11b). A 1/2-inch thick by 10 1/4-inchtall batten is required if the side panel extends upinto the machine compartment area on therefrigerator side (Fig. 11c).Backside of UnitFreezer Side of UnitDoor1/4" side panel fitted up tothe cabinet trim (top view)on Freezer side.3/16"/.48Battens#8-32 1/2"Screw1/4"/.64 Side Panel1/4" side panel fitted up tothe cabinet trim (top view)on Refrigerator side.Backside of UnitRefrigerator Side of Unit1/2"/ 1.27 Battenson side of machinecompartment(3/16"/.48 below themachine compartment)Door#8-32 1/2"Screw1/4"/.64 Side PanelFig. 11cFig. 11bFig. 11a111406-1(061402)

/ 78

Related manuals for Jenn-Air JENN-AIR