Jenn-Air PRG3010 series Service

WARNING! To avoid risk of electrical shock, personal injury or death;disconnect power to unit before servicing.Disassembly Procedures18 16022882 Rev. 0 ©2004 Maytag ServicesRemoving and Replacing Unit1. Turn off power to the oven at the circuit breaker.NOTE: To avoid property damage, place a protectivecovering on the floor.2. Slide unit forward, out of the installation position.3. Disconnect or unplug the power cord leading from unitto junction box or outlet depending on connection.4. Turn off gas supply and disconnect from main gas line.5. Reinstall the oven using the installation instructions.Control Panel1. Disconnect power supply to unit.2. Remove all burner and thermostat knobs from unit.3. Remove torx screws (two at each side) securingthermostat bezel.4. Rotate top portion of control panel forward.5. To fully remove for convenience remove light switch,and disconnect pilot light wires.CAUTION!To avoid risk of control panel damage, protect the panelfront from scratches by placing rags or cardboard overpanel.6. Reverse procedure to reassemble.MaintopNOTE: Unit must be pulled away from the wall for thisprocedure.1. Disconnect power and shut off gas supply to unit.2. Remove burner grates and burner caps from unit.3. Remove dual feed burner flame spreaders and singlefeed burner port rings, by lifting straight up.4. Remove screws securing dual feed burner base tomaintop.5. Remove venturi bolts securing single feed burnerbases to maintop.6. Remove control panel, see “Control Panel ” procedure.7. Remove screws (two on each side) securing landingledge to chassis.8. Remove screws securing backguard island trimassembly to maintop.9. Remove screws securing side panels to chassis.NOTE: All screws on the rear on each side, all screwson front, and one screw located on each frontinside corner of the maintop facing the sides(if equipped).10. Pull bottom portion of side panel out first, then liftupward to remove.11. Maintop can now be lifted off.12. Reverse procedure to reassemble.Light Switch1. Disconnect power supply to unit.2. Remove control panel, see “Control Panel” procedure.3. Disconnect and label wire terminals from light switch.4. Squeeze locking tabs together on each side of theswitch to release from control panel.5. Pull switch through the front of control panel.6. Reverse procedure to reassemble.Terminal Block1. Disconnect power supply to unit.2. Remove control panel, see “Control Panel” procedure.3. Remove screws securing static handle located underthe static handle and above the lower heat shield.4. Remove screws securing lower heat shield on the topside of the heat shield.5. Remove screws securing terminal block to chassis.6. Mount new block and transfer wires from old block tonew block.NOTE: Make sure wires are transferred to correctlocation on terminal block to ensure properoperation.7. For upper terminal block replacement, maintop needsto be removed, see “Maintop” procedure.8. Reverse procedure to reassemble.Light Socket1. Disconnect power supply to unit.2. Open the oven door.3. Unscrew oven light cover, located inside oven cavity.4. Unscrew light bulb and remove.5. Gently pry the three locking tabs inward towardscenter of socket.6. Once locking tabs are released, remove light socketfrom oven cavity.7. Disconnect wire terminals connections and transferwire terminal connections to new light socket.8. Reverse procedure to reassemble.