Jenn-Air PRG3010 series Service

WARNING! To avoid risk of electrical shock, personal injury or death;disconnect power to unit before servicing.Disassembly Procedures22 16022882 Rev. 0 ©2004 Maytag ServicesOven Ignitor1. Remove oven door, see “Oven Door” procedure.2. Remove screws securing kick plate at each topcorner.3. Remove all oven racks and oven rack supports, bylifting upward and pulling the bottom inward towardsthe center of the oven cavity, then downward todisengage from lower support brackets.4. Remove screws securing lower support bracket tooven cavity.5. Remove oven bottom, by lifting upward and pullingforward to removing from oven cavity.6. Disconnect and label wire terminals from oven ignitor.7. Remove screws securing ignitor and shield to theburner.8. Remove ignitor from oven cavity.9. Reverse procedure to reassemble.Gas Regulator1. Disconnect power supply to unit.2. Remove screws securing kick plate at each topcorner.3. Shut off gas supply to range, located in the front of theoven.4. Remove bracket at gas line elbow, located at thebottom left of unit using 5/16” socket.5. Disconnect gas line from left side of the regulator,using a 7/8” wrench on the compression nut and a13/16” wrench on the regulator.6. Remove the regulator from the shut off valve bysecuring the shut off valve with a 1” wrench andunscrew the regulator.NOTE: When reinstalling regulator make sure to usepipe sealer on all threaded connections.NOTE: Verify that there are no gas leaks, by usingsoapy water solution.Griddle Plate Assembly1. Remove flue cover located at the rear of the griddle.2. Remove front trim cover.3. Remove center shipping screw located at the rear ofthe griddle (if applicable).4. Remove screws securing the front of the griddle.5. Lift griddle assembly straight upward to gain access tothermostat capillary tube.6. Slide the thermostat capillary tube out of the griddleplate channel and place to the side.7. Remove griddle assembly from the unit.8. Reverse procedure to reassemble.Griddle Ignitor1. Remove griddle assembly from unit, see “Griddle PlateAssembly” procedure.2. Remove screw securing griddle burner, located at therear.3. Remove burner and place to the side.4. Disconnect wire terminals from ignitor.5. Remove screws securing ignitor and shield to griddleassembly.6. Remove ignitor from griddle assembly.7. Reverse procedure to reassemble.Griddle Thermal Valve1. Remove control panel, see “Control Panel” procedure.2. Remove griddle assembly from unit, see “Griddle PlateAssembly” procedure.3. Remove screw securing griddle burner, located at therear.4. Remove burner and place to the side.NOTE: Orifice can be removed for easier replacement ofvalve.5. Disconnect gas line from manifold elbow to griddlethermal valve.6. Remove screws securing griddle thermal valve bracket.7. Remove valve from unit.8. Reverse procedure to reassemble.Griddle Thermostat1. Remove control panel, see “Control Panel” procedure.2. Remove griddle assembly from unit, see “Griddle PlateAssembly” procedure steps 1 through 6.3. Disconnect wire terminals from thermostat.4. Remove screws securing thermostat to control panel.5. Gently remove sensing bulb through the hole in thefront baffle.6. Reverse procedures to reassemble.