Jenn-Air PRG3010 series Service

WARNING! To avoid risk of electrical shock, personal injury or death;disconnect power to unit before servicing.Disassembly Procedures©2004 Maytag Services 16022882 Rev. 0 23Dual Valve1. Remove griddle assembly from unit, see “Griddle PlateAssembly” procedure steps 1 through 6.2. Remove screws securing the back of the griddleburner hanger.3. Remove back panel assembly.4. Disconnect gas lines from the dual valve.5. Disconnect and label wire terminals from the dualvalve.6. Remove screws securing dual valve to firebox.NOTE: Carefully move the griddle burner baffle out of theway to gain access to screws.7. Reverse procedure to reassemble.Single Thermal Valve1. Remove oven door, see “Oven Door” procedure.2. Remove screws securing kick plate at each topcorner.3. Remove all oven racks and oven rack supports, bylifting upward and pulling the bottom inward towardsthe center of the oven cavity, then downward todisengage from lower support brackets.4. Remove screws securing lower support bracket tooven cavity.5. Remove oven bottom, by lifting upward and pullingforward to removing from oven cavity.6. Remove screw securing burner, located at the rear ofthe burner.7. Disconnect gas line from the single valve.8. Remove nuts securing single valve to mountingbracket.9. Reverse procedure to reassemble.